Start sprinting? #4 (Week 14)

This week I have sent my packaging design to the printing shop which placed at Makhota Cheras. After I collected them, I cut and fold the packaging myself. For the underwear packaging, I need to cu the front part and at the transparent paper on it, so it can look similar to the real product.

Then, for the lubricant bottle model. I start doing the epoxy experiment.Before that, to prevent the glue come out from the mould, I use some tape to stick on the part where I cut before, and put the mould into a cup. Then, I use the small cut that the seller provides and use the ratio 1:2.5 to mix the glue. After scaling, I put the glue into the mould little by little. Then, I need to wait for 24 hour to get a solid epoxy. However, when I take out the model, I find that some part of the epoxy is not flat and clear, so I try to polish the model. Finally, I get a good final outcome for the bottles. And I keep using this method to do the next bottles as well.

After finishing all the packaging design and also the product design, I find that I need a poster to explain my product to my audience so that they can understand the topic of my products easily. Therefore, I try to design a poster. I take some picture for the products, edit it by using Adobe Photoshop. Then, I try to add some element which related to my product and topic, such as the rainbow and also the character design. I have written some explanation of my product on the poster as well.

And this is my final EIP: